What this site is
drillbitsizechart.org is a drill and fastener reference for machinists, welders, woodworkers, mechanics and students. It puts the four drill systems used in North American shops (fractional, number, letter and metric) into one searchable list, and links each size to the things you usually need next: the tap drill, the clearance hole, the thread pitch, the wrench.
The whole site is 434 drill sizes, 47 inch threads, 33 metric threads and the fastener, gauge and conversion tables around them. Everything works in the browser, prints in black and white, and needs no account.
How the numbers are made
- One source file. Every table on the site is generated from one data file, so a value is never typed twice and never disagrees between pages.
- Exact conversions. Millimetres use the exact definition 1 in = 25.4 mm. 1/4 in is 6.35 mm, not 6.3 or 6.4.
- Lowest terms. Fractions are always reduced: 16/64 is shown as 1/4.
- Computed, then checked. Thread percentages, minor diameters, RPM and nearest-size lookups are calculated with the standard formulas and tested against published values before each update. If a published chart and the formula disagree, we show the published value and note the difference.
- Where sources disagree (wood screw pilot holes, some pipe tap drills, ISO and DIN wrench sizes) the pages say so and show both.
Sources
- Wikipedia, "Drill bit sizes" (number and letter gauge tables, after ASME B94.11M)
- Wikipedia, "List of drill and tap sizes" (inch and metric tap drills, clearance holes)
- Wikipedia, "Unified Thread Standard" (UNC / UNF series, number-screw diameters)
- Wikipedia, "ISO metric screw thread" (ISO 261 coarse and fine pitches, basic profile)
- Wikipedia, "National pipe thread" (NPT sizes, TPI, OD, tap drills)
- Engineering ToolBox, "US Wood Screws – Pilot Holes"
- Wikipedia, "Sheet metal" (gauge tables and the weight-per-area basis of the steel gauge)
- Wikipedia, "American wire gauge" (the Brown & Sharpe formula used for aluminum sheet)
- Wikipedia, "Wrench" (bolt sizes and wrench openings, ISO and DIN)
Corrections
If you find a wrong number, email support@drillbitsizechart.org with the page and the value. We check it against the sources above and fix every page built from the same data on the same day.